Building Closet Shelves Plywood

Hardwood faced plywood costs about 50 percent more.

Building closet shelves plywood.

Simply cut another 1 x2 board the length of your shelf minus 3 inches to accommodate the side supports and screw it to the studs along the back wall of the closet. How to use plywood and trim to create diy closet built ins. Two 11 7 8 inch wide long closet shelves to the length that fits the width of your closet in step 1. A sheet of fir faced plywood that gives you enough material for eight 1 by 4 foot shelves costs less than 40.

The rigidity of plywood and composite wood can be improved by gluing on solid wood edges or plastic laminate faces fig. You ll use 3 4 inch plywood to make this closet organizer. We built the entire system with birch plywood. Then cut 2 more pieces 14 1 4 for the side supports.

Everything you need for this project is available at home centers. Strengthening plywood and composite shelves each of these shelves is the same thickness length and width. The minimum thickness you need for. Again don t forget the level.

If you are building straightforward shelves you also need to add wood supports along the back wall of the closet. The total cost including the hardware for the drawers shelves and closet rods was about 250. These plywood shelves with 1x2s for trim saved us over 4000 on a closet system. Six 11 7 8 inch square shelves for the central unit.

Attaching upper shelves to the closets using the remainder of the approximately 2 1 2 left over strips of plywood cut a piece the width of the closet for the back of the shelf support. The solid wood shelf holds up four times the weight of the plain particleboard shelf. You could use mdf or oak plywood instead of birch. A plywood sheet is the best choice for your diy projects because it s lightweight safe and flexible.