Mark holes and pre drill.
Building an a frame blind.
Construct a base using the 2x4s cut to be 4 feet by 8 feet then attach the 1x2 support lumber to steady the structure.
These will become the sides or walls of your blind.
Use a post driver to.
Next attach one of the sheets of plywood as the floor by screwing it on the base.
As i have done over the last few years i build a couple of light weight a frames during the off season for a fraction of the cost of a commercial option.
They are handy mobile and well worth the effort.
Stand this wall up carefully and attach it to the first wall with wire and horizontal supports.
This will frame an entrance to the blind.
Do you put in the time and money to put in an in ground pit blind is the water big enough to warrant a boat blind are you hunting a field so a simple layout blind will do the trick.
This seems to.
Using a framing square and long level make sure each corner is vertical.
Repeat that step driving the remaining t posts into the.
Use 2x4s to start building the frame ensuring the back slopes downward toward the front of the blind.
You might even remember visiting your grandparents a frame home as a kid in all it s wood paneled glory.
Let s talk about the good ol a frame architecture.
A single cattle panel from your local farm supply store is big enough to provide concealment for two or three hunters.
Spread a thin layer of stubble across netting.
I cut mine in half to.
Two 10 long 2x2 run under six bucks.
When it comes to building a duck blind there are so many different routes you can go.
Click the link for our duck blind blueprints for this blind to see the specific measurements and pieces we used.
Well after a stint on the outdated list a frames are.
Gather you stubble and make sure you have plenty of it.
My supplies are modest.
To make the next steps a little easier set up the blind panels just like you would in the field.
These triangle shaped structures were popular in the 1950 s through the 70 s.
40 tips for the perfect a frame cabin.
I frame the blind with 2x2 s at 5 long.
Cut poultry netting to desired length.
This enables water to flow off of the roof.